T3109: This timer is used by the BSC during the dedicated channel
release procedures initiated by the MSC after O&M intervention or
radio link failure conditions. The purpose of T3109 is to ensure the
release of the radio channel in situations in which the MS cannot
confirm connection release messages any more as the dedicated Um
signalling connection has already been lost. After receipt of a CLEAR
COMMAND message from the MSC or a detection of a lower layer
failure the BSC sends a CHANNEL RELEASE message to the MS,
starts T3109 and deactivates the SACCH. The BSC stops T3109
when it has received the RELEASE INDICATION from the BTS,
which indicates that the MS has sent the DISCONNECT message on
the main signalling link. If T3109 expires, the BSC deactivates all
channels for this MS by sending the RF CHANNEL RELEASE
message to the BTS.
To avoid these unnecessary CONNECTION FAILURE
INDICATIONs, it is recommended to set T3109 to a small value, e.g.
the default value HLFSEC-8.
Apa coba.
Iya ak dah g di project Mba..
Sekarang aku ngurusin resource-nya planning utk smua project, aku ikut Bu Mutia :p makanya gantinya Bu Mutia si Pak Sugeng bukan...
Yaudah moga2 kita bisa ketemuan lagi yah ;)
how about ur holiday..
lots of story need to be share..
Great new gossip, hee
love & don't forget to cell group,hee
^_^
release procedures initiated by the MSC after O&M intervention or
radio link failure conditions. The purpose of T3109 is to ensure the
release of the radio channel in situations in which the MS cannot
confirm connection release messages any more as the dedicated Um
signalling connection has already been lost. After receipt of a CLEAR
COMMAND message from the MSC or a detection of a lower layer
failure the BSC sends a CHANNEL RELEASE message to the MS,
starts T3109 and deactivates the SACCH. The BSC stops T3109
when it has received the RELEASE INDICATION from the BTS,
which indicates that the MS has sent the DISCONNECT message on
the main signalling link. If T3109 expires, the BSC deactivates all
channels for this MS by sending the RF CHANNEL RELEASE
message to the BTS.
To avoid these unnecessary CONNECTION FAILURE
INDICATIONs, it is recommended to set T3109 to a small value, e.g.
the default value HLFSEC-8.
Apa coba.
Masa aq kurusan?? kebanyakan pikiran ne.. wakakaka
Sekarang aku ngurusin resource-nya planning utk smua project, aku ikut Bu Mutia :p makanya gantinya Bu Mutia si Pak Sugeng bukan...
Yaudah moga2 kita bisa ketemuan lagi yah ;)
you little sister: ayuk
Apalagi sekarang aku dah ga di project lagi, hiks ga bisa timbilding brg lg dunk...ups *curhat colongan mode on yah kikikik :p
keep in contact yah ;)
KUL DI ELEKTRO UNUD,,ANGKTN BRPA?
THX YACH..